![]() ![]() If you are using Windows fonts in BarTender, then a warning may come up when a print job is initiated asking if you want to continue using this font or if you want to substitute it for a printer font. Printer fonts are natively stored on the printer and geared for performance, while Windows fonts are stored in the Windows fonts folder (C:\Windows\Fonts). There are two types of fonts: Printer and Windows fonts. Select Barcodes and human readable text controlled by BarTender.Open the barcode properties (right click barcode object > Properties).BarTender can send an image of the barcode rather then tell the printer to generate the barcode. If removing the performance settings resolves your issue, you may want to re-enable each performance setting one at a time to see if it's only a specific performance setting causing the issue.īarcodes have an additional performance setting within the barcode properties. Set the available dropdown menus to Raster Graphics.Note: When setting performance optimizations and object print methods you may choose which documents the changes affect: Generally recommended to increase darkness in small increments until the desired printout is produced. Higher speeds may cause labels to skip because the stock is moving too quickly for the sensor to read the stock correctly.ĭarkness: A high darkness setting may break your stock by applying too much heat. ![]() Speed: Slower speeds may produce a clearer printout. Media Handling: These options involve pausing, pausing for tear off, cutting the stock, or backfeeding between labels. Print Method: Direct Thermal (no ribbon) or Thermal Transfer (ribbon). Media/Sensor type: Set whether the sensor is looking for gaps, marks on the back of the stock, or nothing if it is continuous stock. There should be a Stock and Options tab where you can set the following:.To set the driver media configurations through BarTender: Other drivers may have similar options but the interface will differ. Note: The follow options are available when using Drivers by Seagull. Use the preview on the right to verify your BarTender settings match what your stock looks like.Note that the gap in between labels on a roll of stock is handled by the driver and does not need to be entered as a margin. Custom/ User defined page size: If your stock size is not a predefined option then you should enter the height and width measure in step one into the height and width fields.Landscape: This setting is used if you are looking directly at your printer and the printout will be rotated 90* clockwise.Portrait: This setting is used if you are looking directly at your printer and the printout will not be rotated.edge to edge and perforation to perforation).įor more information refer to the help documentation Page Setup Dialog. If the backing of the stock is of a greater width or height than the items, then measure the size of the backing (ie. If you skipped creating a new simple document, then you can use the following steps to check your page setup. We recommend measuring your stock with a ruler as opposed to using the dimensions listed on the labeling package. Change any settings in the problematic document to match the settings in the new simple document. Open the new simple document you created in the previous step and the problematic document, and then compare the Page Setup settings. ![]() Verify your page setup settings match your stock.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |